Thanks DPF for yet more amazing sculpts. As soon as the Pledge Manager went 'live' this morning I downloaded the STL bundle (the process was straight forward). I am fortunate to own an Anycubic Photon Ultra (Digital Light Processing) 3D printer. The resolution it can print is amazing. However I was a little worried merely scaling down a pre-supported file of a 75mm miniature to 32mm scale would mean the supports would be too small / thin and the print would fail. But it printed fine first time, using the settings below.
I rescaled the pre-supported files of Warden from 75mm to 32mm (i.e. 43%). I set the layer thickness on my 3D printer to 0.01mm, created the sliced file and printed. All other slice settings were the default values. Resin used was the grey DLP Craftsman resin. The print took just over 8 hours.......well worth the wait; some pics below.